The smart relay touch V2 Runs with Wemos D1 Mini with 3 relay and 3 touch sensorThe relay input 3A v220-AC max
Tasmota Link Tasmota
Configure Tasmota for Wemos Generic Module In the Configuration -> Configure Module page, select Module Type: "18 Generic" (releases before 5.12.0 this was called "Wemos D1 Mini"). After Saving the settings, the WEMOS reboots with the Generic configuration. The first time you switch to "18 Generic" you will NOT see all the options as seen in the picture below YET. You have to save "18 Generic" first and when you go there again after the reboot you get the long table where you can change all the pin's parameters. These steps are confirmed to also work with the Wemos D1 mini PRO v2.0.0.