Your EasyEDA usage duration is brief. In order to avoid advertising information, this action is not supported at present. Please extend your EasyEDA usage duration and try again.
Editor Version×
Standard
1.Easy to use and quick to get started
2.The process supports design scales of 300 devices or 1000 pads
3.Supports simple circuit simulation
4.For students, teachers, creators
Profession
1.Brand new interactions and interfaces
2.Smooth support for design sizes of over 5,000 devices or 10,000 pads
3.More rigorous design constraints, more standardized processes
2 layer board of 1.59x2.20 inches (40.34x55.88 mm).
Updated rev2
This is a board for an home made tiny USB hub. Board + BOM cost less than 10€/unit for 3 units (Farnell components + OSHpark board + USB chip, see below). Hub is based on Genesys Logic GL850G chip The Genesys Logic (taiwanese manufacturer) chip is the hardest component to find but it only cost 0.67€/unit for 4 units. In Europe, you can find it at Arduiner online store (it).
usb hub (ignore through hole capacitors near quartz, I ordered the wrong SMD capacitors and must use these instead)
You can choose to solder USB0A (A male) or USB0B (B female). USB0A is mainly there because I need to extend Raspberry Pi rev A single port, so I can connect the hub directly to it without cable.
The hub works in bus powered or self powered mode, you just need to solder appropriate jumper. There is no DC jack for self powered, you must connect external supply to EXT 5V.
It is a 3 ports hub but there is a fourth port available via EXT D+/D-.
IMPORTANT There is a bug in this rev0 board with R4 and LED2 : do not solder (board works without that, led is about sleep mode). This is fixed in attached rev1 schematics and board files.
Forked project will be set private in personal workspace. Do you continue?
Clone
Project
The Pro editor is about to be opened to save as. Do you want to continue?
private message
Send message to hahnrobin
Delete
Comment
Are you sure to delete the comment?
Report
USB Hub rev0 copy
No Profile
Announcer: HahnRobin
Creation time: 2019-05-21 14:26:09
Published time:
2019-05-21 14:26:11
*
Report type:
Please select report type
*
Report reason:
Please fill in the reason for your report and the content is 2-1000
words
*
Upload image:
+
Upload image
*
Email address:
Please fill in your email address
Report
*
Report type:
Please select report type
*
Report reason:
Please fill in the reason for your report and the content is 2-1000
words
*
Upload image:
+
Upload image
*
Email address:
Please fill in your email address
Report
Submitted successfully! The review result can be viewed in the personal
center, review notification.
Kind tips
Your EasyEDA usage duration is brief. In order to avoid advertising information, this action is
not supported at present. Please extend your EasyEDA usage duration and try again.
Share
Project
Copy
Copy
Scan the QR code and open it on the mobile terminal