AC Fan Seed Controller with DHT22 (or DHT11) Temp sensor and LCD Display of Temp. UART or I2C options for 16x2 LCD diplay shown. Uses External 240V to 12V DC PSU to provide power to the Arduino Vin pin and the 5V output from the Arduino to provide power for the DHT22 and ZC Probe.
The KY-015 Temperature and humidity sensor module is part of the "37 In 1 Sensor Module Board Set Kit For Arduino" series, looks like a small circuit, on it are mounted, the DHT11 sensor, a resistance and a pinstrip with 3 pin.
For more information see https://win.adrirobot.it/sensori/37_in_1/KY-015-Temperature-and-humidity-sensor-module.htm
Solution to create home network via nrf24 and arduino.
Plus LEDcontrol, DHT11(temperature sensor), IR control, button control, IR motion Sensor.
this is simple project that collect temperature and humidity from DHT11 or DHT22 and broadcast it in the network using protocol UDP
# software #
# hardware #
1) esp8266 wemos d1 mini or nodemcu
2) DHT11 or DHT22
visit my github repository to find qt app for android phone :
code source: https://github.com/salim97/My-Weather-Gadget
wiki : https://github.com/salim97/My...
## Arduino drive the temperature and humidity sensor DHT11 ##
Available as both a plain component or an Electronic Brick.
The photos Electronic Brick: Voltage,Signal, Ground
## 10k pullup resistor needed ##
Needs 4.7K to 10K pullup resistor from +5V to Signal pin. Connect to Arduino MEGA 2560 Digital pin 3, not Analog pin.: When the connecting cable is shorter than 20...