V1.1 UPDATED: The IDE 44 connector was flipped so that the PIN 1 location matches the side on the 2.5" and 1.8" drives. Both V1.0 and V1.1 are electrically identical. This is a mechanical change.
Board was built and tested - working correctly with the JM004-1 and RC80 90 degree expansion boards.
No modifications required.
Create a stackable disk io daughterboard for SC126 - Mechanically Compatib...
1541 Floppy Disk Drive to USB Adapter based on the designs by Till Harbaum and Spiro R. Trikaliotis. For more information visit https://spiro.trikaliotis.net/xu1541.
C64 SD-Card Adapter based on the Shadowolf-design. For more information visit https://www.sd2iec.de.
This board is designed to be a FPGA expansion board using the standard Altera/Tersaic 40-pin header.
It adds a variety of legacy PC interfaces to an FPGA development board to aid in implementing and demonstrating retro PC hardware.
Adds the following interfaces:
- One HDMI Video Port
- One Serial Port (COM port)
- One Parallel Port (LPT port)
- Two PS/2 Ports (for Keyboard and Mouse)
- One MIDI /...
original enhanced gotek cloned from fikus842
I removed the smaller floppy connector (not used in Amiga) to created extra space to place the stm32 later and added the blue pill pinout for now.
the Blue Pill is used for ff_OSD (on screen display of the flash floppy info) and selection through the Amiga Keyboard.
This is the first setup, and connetors of the ff-osd are missing the power (GND + Power...