This is a WIFi controller module to control a strip of single colour 12v LED's via a home automation system (OpenHab)
It can also be controled via MQTT commands (if ESPEASY firmware is loaded into the WEMOS D1.)
It can be used for any application that required control of an LED Strip.
My personal use and reason for designing this module was to give my wife some improved lighting in the kitchen (u...
A very small unit for controlling RGB LED Strips.
All outputs should be pwm and i personally use OPENHAB2 for my MQTT Broker.
Flash with espeasy or Tasmota and set up to your own system.
I have several of these around my home and they work perfectly everytime.
Tried and tested :)
It has a space for a PIR sensor and a room temperature sensor
Will work with any MQTT Broker if set up for it.
This is a battery powered sensor board based on the ESP8266 (ESP-12F).
By using a TPL5111 chip the battery consumption can be reduced to about 1µA when the ESP is not enabled. When the TPL5111 chip receives 5V at it's wake up pin this will turn the ESP on by enabling the 3.3V voltage regulator. At this moment you can run any program you want. If you want to turn the ESP off again you have to drive...