2.4GHz Wireless Dev Kit.
Sensor board powered by CR2032 battery. Each sensor board has RJ11 input for landline phone line and three discrete/analog inputs, discrete outputs for other use.
Controller board powered by 12V DC. Controller drives LED strip WS2811. Color of light motion depends on activated sensor and its channel.
Primarely used as an intercom and a landline ring light indicator for peo...
As the title, LED dimmer. Tired or turing on lights at night just to get blinded by being so bright. This is a small LED dimmer that can be put beside your bed at night table or just stuck to the bed it self.Allows gradual ON and OFF dimming or full ON.
Learning from version 1, version 2 changessecond channel from low to high FET PWM current directly controlled by input ie PIR/motion sensor to. Ad...
Stand-alone High Voltage Serial Programmer and Fuse Resetter for ATtiny 13/25/45/85.
Project Video: https://youtu.be/2Q7D2RwkOMg
This work is licensed under Creative Commons Attribution-ShareAlike 3.0 Unported License.
Display-Module created and developed for Eurorack-Synth-Modules.
Digit height: 5.03mm !
Module size (w x h): 20.7mm x 22.86mm
For following controllers:
Example code using Attiny84:
Small development board for using an ATtiny44A or similar 14-pin ATtiny in SMD package on a breadboard.
Minimal hardware design featuring only MCU, breadboard friendly headers with extra power lines, ISP header for serial programming and reset button.
Uses bare chip and limited extra components.
Also usable for ATtiny84, ATtiny441 and ATtiny841.
You can find some more [information about the project on my website https://josef-adamcik.cz](https://josef-adamcik.cz/electronics/led-cube-4x4x4x-attiny84-74138.html)
Gallery with finished build [available on imgur](is available on imgur).
A [source code for attiny84 is at Github](https://github.com/josefadamcik/ledcube_4x4_double74138).