Cool Nixie Tube Clock, design works out of the box. All parts (execpt for the tubes) can be ordered from LCSC, if you have any questions feel free to contact me via easyeda messages.
It is recommended to put the nixie tubes on special nixie tube pins, these can be found on ebay.
I'm currently working on an enclosure.
NOTE:unconnected lines between top and bottom board are OK. The PCB is grooved...
A project based in LIXIE project founded in hackaday blog. Link : https://hackaday.io/project/18633-lixie-an-led-alternative-to-the-nixie-tube
But this clock don't have (yet) a µC because this was thought to be a project subjects studied in university
Now i'll going to do the v.2 model with some improvements
"The Missing Module"
Pairing this module with S. Cousins SC108 (CPU+memory) or SC114 SBC form a complete CP/M computer system.
The beauty with #61 is that it can be used as a
1) bus clock
2) serial interface
4) or a combination of these functions.
In addition, it allows the CPU to run asynchronously up to 24Mhz (Z80) or 33Mhz (Z180)
This is the code I use for the clock. Feel free to change it in each manner your want. ATTENTION: Dont use the POV Clock_old. I use it for backup purpose only. It wont work! The file POV Clock_new and POV_Clock_new_SSD1306 are working well and are fully tested. But i dont take any responability if something dont work like you want. For example: the optocoupler is tricky. Maybe you need to adjust t...