Homely WSN Basic Board V2 is an IoT board to collect environmental data (temperature, humidity, and pressure) and to push them to a centralized server through Wi-Fi. This is the enriched successor of the Basic Board V1, that improves different aspects:
- energy efficiency (lower consumption during deep-sleep)
- onboard recharge for single-cell Lipo battery
- measurement of battery level based on...
Homely WSN Basic Board (V1) is an IoT board to collect environmental data (temperature, humidity and pressure) and to push them to a centralized server through Wi-Fi. [Here](https://www.thingiverse.com/thing:4573333) you can find a 3D-printable case to protected the circuit.
## Main components
- ESP8266 (ESP-12S)
- Digital temperature and humidity sensor Sensirion SHT30
- Digital temperature and...
Powered by 2 AA Batteries Size 20 x 45 (mm) Almost SMD 0805 Atmel328p TQFP32 NRF24I01 smd ATSHA204A chip FLASH for OTA FTDI, ISP SHT21 Sensor
The Sensor works directly on two AA Batteries or Ni-MH.
Use Sensebender Micro bootloader Set Fuses before upload bootloader FUSES: L: 0XDE // H: 0XD2 // E: 0X07 (disabled BOD/8Mhz external clock) Set Fuses again,...
Temperature, humidity and luminance sensor based on ESP12-E (ESP8266).
- The temperature and humidity sensor is DHT22, but you can setup any other.
- The pir sensor could be any with abinary digital output.
- The luminance sensor is based on ADC
USB port is only for power (you can also power it by the header male pins).
For programming you have to use the UART pins.
Universal board for Arduino Nano and UNO and Nano shield with NRF24L01 transmitter, 16x02 LCD I2C SPI (PCF8574) display, two KY-040 Rotary Encoder, GY-521 ITG/MPU (MPU6050), Adafruit 9DOF (LSM303DLHC+L3GD20), MH-FMD BUZZER, DHT11 Humidity & Temperature Sensor, BME280 Pressure Humidity Temperature Sensor Module, MQ-8 and MQ-9 GAS SENSOR, With additional areas for dip and soic.
## Arduino drive the temperature and humidity sensor DHT11 ##
Available as both a plain component or an Electronic Brick.
The photos Electronic Brick: Voltage,Signal, Ground
## 10k pullup resistor needed ##
Needs 4.7K to 10K pullup resistor from +5V to Signal pin. Connect to Arduino MEGA 2560 Digital pin 3, not Analog pin.: When the connecting cable is shorter than 20...
**Description**:The **HTU21D** is a low-cost, easy to use, highly accurate, digital humidity and temperature sensor. This sensor is ideal for environmental sensing and data logging and perfect for a weather stations or humidor control systems. All you need is two lines for I2C communication and you’ll have relative humidity readings and very accurate temperature readings as a bonus!
There are o...