Today Carbon Monoxide meters are available in different forms. Overall, Carbon Monoxide meters sense CO fast and display the amount to the user and trigger alarm if it reaches a critical level. Compare with most of the DIY Carbon Monoxide meters, the project which we described in this article does not need any development platform or MCU / firmware. The Carbon Monoxide meter in this project design...
LM393 Low Power Dual Voltage Comparators DIP-8 test circuit.
Very inexpensive and a good way to learn about OpAmps. Needs 9 volts to operate.
Switch not in schema or PCB, added while building.
Zip file contains a short video of the circuit working.
Tested with DBL358, IR3F02, IR9082, IR94558, JRC4558D, NE5532, KIA393P, HA17393
![enter image description here]
![enter image de...
Seconsor controlled relay to be used for pump, main switch etc. S1 switch to be replace by magnetic water sensor (sump), photocell etc. For sump (drain pump) a timer might be needed to delay the start. This depends on the lenght of the sensor.
This is a simple but efficient voltage regulator / buck-converter circuit.
High Side Mosfet driver for elegence and a 393 to power the charge pump and for the comparator circuit.
The IRF540 will power to 5A but the circuit will function at higher powers by changing the MOSFET.
The Zener Reference is 7.1v which the trim pot then allows you to select the output voltage (which must be lower). If...