The driver module uses the Chinese-made MX1508 chip.
It can be connected to an Arduino UNO R3 board, it can control two motors independently in both directions, in H-bridge configuration with a current of 800 mA, with a peak current of 2.5 A, it has an internal system of temperature control
For more information see https://www.adrirobot.it/modulo-motore-mx1508/
![enter image description here][1]
![enter image description here][2]
![enter image description here][3]
**DESCRIPTION**
The Grove – Mini I2C motor driver is a very tiny motor driver with I2C interface, and it includes two motor driver chips - DRV8830, which helps you control two DC motors or winding of stepper motors on a small board simultaneously.
With four solderable pads back of...
![enter image description here][1]
![enter image description here][2]
![enter image description here][3]
![enter image description here][4]
![enter image description here][5]
**DESCRIPTION**
The 4A Motor Shield is based on the Freescale MC33932 dual H-Bridge Power IC , which can control inductive loads with currents up to 5.0A peak per single bridge. It lets you drive two DC motors with...
A simple H bridge motor driver circuit developed based off a design by @Amit_11710423. This circuti and PCB was desgned to Drivebrushed DC motors for use in LEGO contraptions but will drive any BDC motor less than 110W.
We use cookies to offer you a better experience. Detailed information on the use of cookies on this website is provided in our Privacy Policy. By using this site, you consent to the use of our cookies.
