WS2812B LED Wifi control with music visualizer
I designed this PCB to be used with a project from Instructables to build a sound reactive lamp. Take a look at the project if you want to build it for yourself: https://www.instructables.com/id/Wireless-Music-Reactive-Floor-Lamps/
As you see in the linked project, i changed the schematic a bit. I've added the sound detector to the lamp pcb and rem...
Simple module for creating your own led lamp. You can use RGB strip, WS2812b, one-color strip or others.
![enter image description here]
NeoPixel led strip controller, designed especially for led suits. It can:
- display animation - sequences of frames at regular (given) interval,
- switch animations on MIDI event - note on/off, velocity used for brightness adjust,
- MIDI over UDP over WiFi (UDP broadcast so far, but i'm working on multicast),
- use regular SD card to storage animations.
[These guys use them] for...
Inspired by http://samopal.pro/snowflake2/
Low-speed, high resolution pixel poi based on WS2812B LED strip.
*This design has not yet been built and tested*
Cascade-able 5 Chip Neopixel board suitable for decorative lamps especially using the ESPEasy NeoFlame plugin.
Should work well with any Neopixel application that is suitable for groups of five LEDs.
This board is for individual WS2812b LED chips. Not the ones pre-mounted on a heat sink pcb with resistor and capacitor already installed.
This PCB is designed to drive five strips with WS2812B LEDs (or their variants) along with a Raspberry Pi (any version) from a single ATX power supply unit.
The five 5V ATX power rails are distributed to the five LED strips. While the data is forwarded between the strips.
The data path starts at the Raspberry Pi, which is connected to the first LED strip. From the end of the firs...
A little pcb to sum up the connections from the esp8266 and the ws2812b led strip.
Also there is a easy way for power IN and OUT.
The top connector is for power IN or OUT.
The second connector is for the serial communication.
The third connector is for power IN or OUT.
The last connector is for the ws2812b led (strip).
"-" means GROUND (GND)
"+" means +5Volt (+5V)
"T" means Transmit (TXD0)