*This design has not yet been built and tested*
Cascade-able 5 Chip Neopixel board suitable for decorative lamps especially using the ESPEasy NeoFlame plugin.
Should work well with any Neopixel application that is suitable for groups of five LEDs.
This board is for individual WS2812b LED chips. Not the ones pre-mounted on a heat sink pcb with resistor and capacitor already installed.
This PCB is designed to drive five strips with WS2812B LEDs (or their variants) along with a Raspberry Pi (any version) from a single ATX power supply unit.
The five 5V ATX power rails are distributed to the five LED strips. While the data is forwarded between the strips.
The data path starts at the Raspberry Pi, which is connected to the first LED strip. From the end of the firs...
A little pcb to sum up the connections from the esp8266 and the ws2812b led strip.
Also there is a easy way for power IN and OUT.
The top connector is for power IN or OUT.
The second connector is for the serial communication.
The third connector is for power IN or OUT.
The last connector is for the ws2812b led (strip).
"-" means GROUND (GND)
"+" means +5Volt (+5V)
"T" means Transmit (TXD0)