Arduino with Ethernet

4 years ago 695
  • Description
  • Documents
  • BOM
  • Attachments
  • Members
  • Comments


2 layer board of 3.50x2.00 inches (88.90x50.75 mm). This is a ‘328 compatible board with ENC28j60 Ethernet (etherCard library). The original is from “drj113” over at His board was laid out in KiCAD which I don’t use so I converted it to Eagle and also swapped the SMD parts for regular ones. I replaced the DIP Switches with a dual header thus allowing the recovery of the analog inputs if desired. I use DHCP wherever possible and so selecting a fixed IP (see the Instructable) is very limiting for me as well as requiring me to write stuff down. I needed a few boards for some “embedded” projects around the shack. One of these boards will get pressed into service as an NTP clock with 20x4 LCD making use of the I2C pins to run the LCD.


Arduino with Ethernet






The owner does not allow comments in this project now

Comments (0)

如果需要转移工程请在个人中心 - 工程 - 工程高级设置 - 下载工程,下载后在 打开保存即可。
有问题联系QQ 3001956291 不再提醒
svg-battery svg-battery-wifi svg-books svg-more svg-paste svg-pencil svg-plant svg-ruler svg-share svg-user svg-logo-cn svg-double-arrow
We use cookies to offer you a better experience. Detailed information on the use of cookies on this website is provided in our Privacy Policy. By using this site, you consent to the use of our cookies.