Recommend Projects

Offset Attenuator v1.0

4 years ago 529
  • Description
  • Documents
  • BOM
  • Attachments
  • Members
  • Comments


2 layer board of 2.58x0.97 inches (65.41x24.66 mm). A 4MHz offset attenuator for radio direction finding. Mostly based off this design with a few modifications: 3 position switch: Off, On (10db pad bypassed), and On with 10db pad. Better filtering LPF from 4MHz oscilator to mixer section, an LC instead of RC (replaced 100ohm resistor with 15uH inductor.) Should leak less RF. The board is designed to fit into a ½" conduit pass-through box, like what you might put on the handle end of a measuring tape yagi (Google it; there are MANY plans and designs for them.) Only parts that are “special” are: 2P3T Rotary Switch 15uH Inductor 10k Pot 4MHz Oscillator 5vDC TO-97 Regulator The rest are just standard cheap-o resistors, capacitors and 1N4148 diodes, with values as labeled on the board. Easiest way to get a hold of me is probably on Twitter: @SmittyHalibut. Shoot me a note with your experiences if you use this board! Thanks!


Offset Attenuator v1.0






The owner does not allow comments in this project now

Comments (0)

如果需要转移工程请在个人中心 - 工程 - 工程高级设置 - 下载工程,下载后在 打开保存即可。
有问题联系QQ 3001956291 不再提醒
svg-battery svg-battery-wifi svg-books svg-more svg-paste svg-pencil svg-plant svg-ruler svg-share svg-user svg-logo-cn svg-double-arrow
We use cookies to offer you a better experience. Detailed information on the use of cookies on this website is provided in our Privacy Policy. By using this site, you consent to the use of our cookies.