GPL 3.0

Recommend Projects

enstop hall effect5v to 3.3v logic

1 year ago 355
  • Description
  • Documents
  • BOM
  • Attachments
  • Members
  • Comments


Latching hall effect sensor for ESP32 grbl. This should provide 2.5v until the field latches and then drops to GND and the LED goes out. This is a bit of a hack so I can use cheap hall sensors that typically need 4.5v min voltage to operate. This works fine with a level shifter but the shifter adds many wires to the existing many wires... If the LED fails closed it it may cause issues with the non 5v tolerant GPIO of the ESP32 but this should be rare.

The RJ11 wires are yellow +5v, Green GND, red Signal

TODO: i need to build a mounting case for this and to get the correct 90 degree rj11 connectors.


a rj11 type 1 schematic

hall 5v to 3v logic endstop

rj11 type 2 connector schematic

rj11 type 1

rj11 type 2 connector voltage divider

5v to 3.2v hall effect sensor with voltage divider

test rj11 type 2 connector voltage



ID Name Designator Footprint Quantity
1 4.7k VDR1 AXIAL-0.3 1
2 20k VDR2 AXIAL-0.3 1
3 47k VDR3 AXIAL-0.3 1
4 RJ11 VDRJ1-47K,RJ1 6P4C 2
5 US1881 Hall Effect Sensor latching VDU1,U1,U10 SIP-3P-2.54MM-TE 3
6 LED LED1 1206 1
7 10k R1,R10 AXIAL-0.3 2
8 DS1133-S40BPX RJ10 RJ11-1 1
9 LED10 LED10 1206 1




The owner does not allow comments in this project now

Comments (0)

如果需要转移工程请在个人中心 - 工程 - 工程高级设置 - 下载工程,下载后在 打开保存即可。
有问题联系QQ 3001956291 不再提醒
svg-battery svg-battery-wifi svg-books svg-more svg-paste svg-pencil svg-plant svg-ruler svg-share svg-user svg-logo-cn svg-double-arrow
We use cookies to offer you a better experience. Detailed information on the use of cookies on this website is provided in our Privacy Policy. By using this site, you consent to the use of our cookies.