LGPL
Replaces TI99/4A power board to allow it to be powered with a 13v to 19v DC Power Supply
Make sure to check the pinout on your original power board, the pinout is the same as my (UK) model but i've heard there are different pinouts on other models, so you may need to make an adapter cable
in the UK i've had success here:
The Original TI99/4A Power Board is REALLY thin, I made this at 1.6 and it fit, but there was a little fighting with the case. You might want to see if you can get it made thinner, although the ground plane does make that harder.
I've successfully made a board with 0.8 thickness on JLCPCB and it works fine
ID | Name | Designator | Footprint | Quantity |
---|---|---|---|---|
1 | Barrel Jack | P1 | HDR-1X2/2.54 | 1 |
2 | Header-Male-2.54_1x4 | TI99 | DIP-1X4P-3.96MM-SK | 1 |
3 | Slide_Switch | U1 | SLIDE_SWITCH | 1 |
4 | LED-5MM | LED1 | LED-5MM/2.54 | 1 |
5 | V7812-1000 | U5 | V7812W-500 | 1 |
6 | 22uf 16v | C9,C5 | CAP-D5.0×F2.0 | 2 |
7 | 10uf 25v | C8,C7 | CAP-D5.0×F2.0 | 2 |
8 | 220 | R1 | L_AXIAL-0.4 | 1 |
9 | 10uf 50v | C1,C3 | CAP-D5.0×F2.0 | 2 |
10 | V7805-2000 | U3,U4 | V78031500 | 2 |
Comments (0)