Three axis nano

1 year ago 179
  • Description
  • Documents
  • BOM
  • Attachments
  • Members
  • Comments


1、Module description: Ultra low power consumption: VS= 2.5 V (typical)
Measurement mode is as low as 23uA
The power consumption of 0.1 A in standby mode is proportional to the bandwidth.
User selectable resolution of 10 bit fixed resolution full resolution
Resolution increases with the increase of g range, up to 13 bits (in all the g range to maintain a ratio of 4 mg/LSB). The patent application for the embedded memory management system using FIFO technology, the host processor load to a minimum. Single and double vibration detection
Active / inactive monitoring
The free fall detection power supply voltage range: 2 V to 3.6 V
I / O voltage range: 1.7 V to SPI VS (3 wire and 4 wire) and I2C digital interface flexible interrupt mode
Can map the arrival of an interrupt pin through serial command optional optional range of measurement bandwidth
Wide temperature range (-40 degrees C to +85 degrees C) 2、Function Description: ADXL345 is a small and thin ultra low power 3 axis accelerometer, high resolution (13 bits), the measurement range of + 16g. The digital output data for 16 binary format, through SPI (3 wire or 4 wire) or I2C digital interface to access. ADXL345 is very suitable for mobile device applications. It can be used to measure the static gravity acceleration, but also can measure the dynamic acceleration caused by motion or impact. Its high resolution (3.9mg/LSB), can measure the tilt angle of less than 1 degrees. The device offers a variety of special detection functions. 3、Description of each function module:

enter image description here

4、Components and PCB diagram before welding:

enter image description here

5、Physical map after welding:

enter image description here

enter image description here

enter image description here


三轴 nano



ID Value Qty. Package Components Manufacturer Part
1 ADXL345 1 ADXL345z U1
2 10R 1 3-0603 R1
3 0.1uF 1 C-0603 C1
4 10uF 1 C-0603 C2
5 Arduino-nano 1 Arduino-nano U2



Members / Participants(1)

Login or Register to add a comment

Comments (0)

如果需要转移工程请在个人中心 - 工程 - 工程高级设置 - 下载工程,下载后在 打开保存即可。
有问题联系QQ 3001956291 不再提醒