**************Introducing Frog-0 module of wounder ********************************* This is meant to be a Open Hardware Force sensor module for my 2 row key board (piano/organ) I work on. I alway like 2 row of key on an organ and the fact it can act like may Interments. I also alway like the piano because you can express your mod on how hard you hit the keys. I'm trying to merge the 2. **************WARNING******************* **********PLEASE NOTE******************* This is in the design state an not even pre-alpha-beta state my info in schematic might be wrong and going to be changing it as needed. ****************The plan *************** This board is meant to be use along with the sensor film kit and many other parts I have not figure out yet. The plan is to take the sensor film kit git rid of the metal sheet as use 2 of these board stack one top of the other and screw them together. Note like I said this In planing stat I have not test anything out yet. I Think I can use a peace of sensor film kit from (sensorfilmkit.com) as small as 12mm x 18mm. I would suggest only to cut what you need if you decide to work with me on this board and a 300k ohm resister. I have done some test at home and these value are not quite random. Take two of these board solder a wire to each of the metal pad below the pad an put 3.3 or 5 volt into each. This board is meant to test may different things. Please let me know if you interest in my project. If I see people are interest and want to work with me on this I will try to give more info as I go along. I have a job and writing dose take a-lot of time away from me And there is no sense on doing it if no one is interested.