Editor Version ×
Standard

1.Easy to use and quick to get started

2.The process supports design scales of 300 devices or 1000 pads

3.Supports simple circuit simulation

4.For students, teachers, creators

Profession

1.Brand new interactions and interfaces

2.Smooth support for design sizes of over 5,000 devices or 10,000 pads

3.More rigorous design constraints, more standardized processes

4.For enterprises, more professional users

Ongoing

STD ESP8266 Fluid Programmer

License: Public Domain

Mode: Editors' pick

  • 1.1k
  • 0
  • 1
Update time: 2022-02-13 11:37:40
Creation time: 2021-04-23 06:54:55
Description


With the \*\*FT232RL FTDI USB To TTL Serial Converter\*\* Adapter Module For Arduino \(link below\)\, you can program an ESP8266\-01 module as fluidly as you can a standard Arduino\. No need anymore to initiate two resets for each programming cycle\. Here is the Serial Adapter: [https://www.amazon.com/gp/product/B07XF2SLQ1](https://www.amazon.com/gp/product/B07XF2SLQ1) And you will need this for the ESP8266: [https://www.amazon.com/Gikfun-2-54mm-Female-Straight-Connector/dp/B01IHBCO2K](https://www.amazon.com/Gikfun-2-54mm-Female-Straight-Connector/dp/B01IHBCO2K) Pretty much any N-channel MOSFET will work, but the origial design calls for a IRF540. The 100µF capacitor is necessary for proper timing with bringing the RST and GPIO0 pins low then high in the right sequence, but once you use this circuit, you can program an ESP8266 just as you can program any Arduino such as a Nano or an Uno. With the inclusion of the DTR and RTS pins which is how the resetting and timing stuff is done, it will reset and be in the proper state when a program is uploaded then once it's uploaded, it will reset and be available for monitoring via the terminal monitor. All without needing to press any buttons or perform manual pin change changes that you would otherwise need to do. On the home etched board, you will need to solder one wire between pin 1 of the header and the RXD pin on the Serial borad. I ordered the PCB for Fabrication from JLCPCB and I can confirm that it works perfectly! Set the Serial adapter to the 5 volt setting. The only pin on the ESP that is sensitive to 3 volts is the VCC pin. This project was inspired by RuiMonteiro's Instructable, which you can find here: [https://www.instructables.com/id/FTDI-ESP8266-Definitive-Wiring/](https://www.instructables.com/id/FTDI-ESP8266-Definitive-Wiring/) Enjoy!
Design Drawing
schematic diagram
1 /
PCB
1 /
The preview image was not generated, please save it again in the editor.
Project Attachments
Order File name Download times
1

IMG_0117.png

3
Project Members
Target complaint
Related Projects
Change a batch
Loading...
Add to album ×

Loading...

reminder ×

Do you need to add this project to the album?

服务时间

周一至周五 9:00~18:00
  • 0755 - 2382 4495
  • 153 6159 2675

服务时间

周一至周五 9:00~18:00
  • 立创EDA微信号

    easyeda

  • QQ交流群

    664186054

  • 立创EDA公众号

    lceda-cn