Your EasyEDA usage duration is brief. In order to avoid advertising information, this action is not supported at present. Please extend your EasyEDA usage duration and try again.
Editor Version×
Standard
1.Easy to use and quick to get started
2.The process supports design scales of 300 devices or 1000 pads
3.Supports simple circuit simulation
4.For students, teachers, creators
Profession
1.Brand new interactions and interfaces
2.Smooth support for design sizes of over 5,000 devices or 10,000 pads
3.More rigorous design constraints, more standardized processes
4.For enterprises, more professional users
Ongoing
STD
high current power supply
License: CC-BY-SA 3.0
Mode:Editors' pick
656
0
0
0
Update time:
2021-01-09 17:17:19
Creation time:
2018-04-19 00:48:58
Description
1-Si desea hacer una fuente de poder que entregue más corriente , por ejemplo, 8 amperes, se debe colocar mas transistores en paralelo.
1-If you want to make a power source that delivers more current, for example, 8 amps, you should place more transistors in parallel.
1-Om du vill skapa en strömkälla som levererar mer ström, till exempel 8 ampere, borde du placera fler transistorer parallellt.
2-El transformador para este proyecto puede ser de 12 voltios y 3 amperios. Así no se cae el voltaje cuando la carga pida corriente. Debe tener una equivalencia entre lo que entrega el transformador y lo que requiere el circuito. Tenga en cuenta que si usa un transformador con un amperaje debajo del requerido, afectará el voltaje de salida.
2-The transformer for this project can be 12 volts and 3 amps. This will not drop the voltage when the load requests power. It must have an equivalence between what the transformer delivers and what the circuit requires. Note that if you use a transformer with an amperage below the required one, it will affect the output voltage.
2-Transformatorn för detta projekt kan vara 12 volt och 3 ampere. Detta sparar inte spänningen när belastningen begär ström. Det måste ha en likvärdighet mellan vad transformatorn levererar och vad kretsen kräver. Observera att om du använder en transformator med en strömstyrka under den nödvändiga, kommer det att påverka utspänningen.
Forked project will be set private in personal workspace. Do you continue?
Clone
Project
The Pro editor is about to be opened to save as. Do you want to continue?
private message
Send message to alvarox6045
Delete
Comment
Are you sure to delete the comment?
Report
high current power supply
No Profile
Announcer: ALGIZ
Creation time: 2018-04-19 00:48:58
Published time:
2021-01-09 17:17:19
*
Report type:
Please select report type
*
Report reason:
Please fill in the reason for your report and the content is 2-1000
words
*
Upload image:
+
Upload image
*
Email address:
Please fill in your email address
Report
*
Report type:
Please select report type
*
Report reason:
Please fill in the reason for your report and the content is 2-1000
words
*
Upload image:
+
Upload image
*
Email address:
Please fill in your email address
Report
Submitted successfully! The review result can be viewed in the personal
center, review notification.
Kind tips
Your EasyEDA usage duration is brief. In order to avoid advertising information, this action is
not supported at present. Please extend your EasyEDA usage duration and try again.
Share
Project
Copy
Copy
Scan the QR code and open it on the mobile terminal