A breadboard-compatible dual non-inverter audio amp built around an opamp.
Exposes most of its internals on pins for more versatility (variable gain, simple filter, ...). Some parts are optional.
Can be stacked to create a mixer with 1 board per stereo channel and 1 board for a master volume.
Small development board for using an ATtiny44A or similar 14-pin ATtiny in SMD package on a breadboard.
Minimal hardware design featuring only MCU, breadboard friendly headers with extra power lines, ISP header for serial programming and reset button.
Uses bare chip and limited extra components.
Also usable for ATtiny84, ATtiny441 and ATtiny841.
This is a breakout board for attaching ZIF-50 connector with a breadboard.
I use it to connect EastRising displays to a breadboard, using [this](https://www.buydisplay.com/default/50-pin-0-5mm-pitch-top-contact-zif-connector-fpc-connector) or [this](https://www.buydisplay.com/default/50-pin-0-5mm-pitch-bottom-contact-zif-connector-fpc-connector) connector.
Reflowing these connectors successfuly...
A selection of breadboard jumpers with fixed length. Useful for single layer PCB wich needs this type of jumpers.
The jumpers can be purchased in Aliexpress, or any big chinese store.
The lengths are: 2,5,7,10,12,15,17,20,22,25, and 50 mm
PCB Breadboard made to fit the pinout of the AdaFruit Feather Line (and other tiny boards and chipouts with a .9"/900mil DIP stance) without compromising on the number of open bus strip holes. also, adds additional bus strips down the middle of the board.
Narrow form factor development board for ATtiny85, ATtiny45 and ATtiny13A.
Minimal hardware design featuring only MCU, breadboard friendly headers with extra power lines, ICSP header for serial programming and reset button.
A 30-pin mini-breadboard with power input via Barrel Jack or microUSB. Top and bottom positive strips can be separate voltages or joined by a jumper. Bottom strip is powered from barrel jack. Top strip is powered from microUSB.
A derivative of the 30-pin breadboard by Johan_a.