USBasp - USB ISP/TPI programmer for Atmel AVR microcontrollers based on the design by Thomas Fischl.
Narrow form factor development board for ATtiny85, ATtiny45 and ATtiny13A.
Minimal hardware design featuring only MCU, breadboard friendly headers with extra power lines, ICSP header for serial programming and reset button.
Just a small experiment to see if I can use EasyEDA to design a PCB.
This project takes a 6 or 10 pin AVR ISP programming cable and converts it to an inline set of pins suitable for a breadboard.
The 6 and 10 input pins are:
MISO o o VCC VCC o o MOSI
SCK o o MOSI GND o o Not Connected
RESET o o GND GND o o RESET