Fits in type 6063-T5 aluminum junction boxes 71*25*85mm
PIC Firmware (as a complete MPLABX Project) attached for a basic transparent gateway function.
Only 300 lines with no dependent libraries so Easy to understand and modify to your favourite CPU as required.
This is a LoRa node, powered by the ESP32 WROVER-B microcontroller. ESP32-WROVER-B is a powerful, generic WiFi-BT-BLE MCU module that targets a wide variety of applications, ranging from low-power sensor networks to the most demanding tasks, such as voice encoding, music streaming and MP3 decoding. ESP32-WROVER-B features a 4 MB external SPI flash and an additional 8 MB SPI Pseudo static RAM (PSRA...
A multipurpose LoRa microcontroller board based on the Atmel 328P microcontroller with an RFM95W LoRa module attached. This version also has an onboard solar power LiPo charger for the integrated 18650 LiPo battery.
Lora Node with integrated PCB-Antenna 868MHz for WaziUp and LowCostLoRaGw https://github.com/CongducPham/LowCostLoRaGw.
Thanks to: https://github.com/cernohorsky/LoRa-Node !
I added a connection for a DS18B20, a LED and a serial GPS-Module.
Burn fuses like this, that the Atmega is working down 2.8V:
**https://forum.mysensors.org/topic/7296/how-to-burn-fuses-so-that-pro-mini-3-3v-would-go-down-to...
PLC remote monitoring. Lora & ESP32 based. Range 3km - 8km. Solar autonomy satelit.
Measuring the water level in a water tower. Testimony transmission via radio channel (air).
Universal useable MiniPill with LoRa capability
Using STM32L051C8T6 chip
Version 1.2: R2 to GND instead of VCC
for more information visit www.iot-lab.org
# ESP32 LoRa Shield
---
This project is a shield for ESP32 wich implements power conection using jack p4 and pin connections using terminal screw connectors.
Mostly one layered project (except one wire) with Arduino pro mini 3v3 board and LoRa RA-2 module. Soldering the shorter header 1x6 strongly optional, in that case you have to solder the LoRa 3v3 pin to Arduino regulated 3v3 VCC.
UPDATE:
PCB V1.1 has no 1x6 header (FTDI).
**Be careful** with the PCB, because the LoRa module was flipped and the nets were not renamed. It is ideal for home etching...
Suitable as either a gateway or a node:
Uses enclosure VG-AL53 or Waterproof ABS Enclosure Type VE838 with battery and thermister for stand-alone Lora Node, can be used as Node (battery + I/O for sensors) or gateway with an FTDI/USB serial cable (https://www.aliexpress.com/wholesale?catId=0&initiative_id=&SearchText=VG-AL53) connected to the host computer.
Version 2 with corrected ICSP connectio...
We use cookies to offer you a better experience. Detailed information on the use of cookies on this website is provided in our Privacy Policy. By using this site, you consent to the use of our cookies.
