Need to replace old broken defroster in my 240z but can not find any that are still working. Also needed to add switch to fog lights so figured willcombine the 2 plus add couple other functions to the controller and solve everything with single module to have following:
- defroster with auto shutoff 10 minutes
- fog switch dual filament one will be used as DRL.
auto shutoff with ignition swit...
This is a simple Timer switch using Arduino and DS3231.
Change the relay type to your specific load.
The program and more details can be found on [github](https://github.com/praveens-git/Timer_Switch_RTC)
This is a small pcb that is designed to be used on an electric go-kart to display a stopwatch, motor RPMs, and cart speed as well as record this data on an SD card with a time stamp for analysis. The project is Arduino based and is ran off of 7-59 VDC or directly from a 5V source through any of the 5V or VIN pins on the data logger shield (this is not a protected input). It is designed to have w...
Apesar do nome estranho, o projeto possui as funcionalidades do título.
A primeira é um "**caçador de vampiros**" de energia (baseado no projeto TOMADA INTELIGENTE do Br-Arduino.org com uso do Attiny85), que consiste em eliminar o consumo de energia dos equipamentos em espera (stand by). Diferente do Tomada Inteligente, este não faz uso de uma régua, mas sim de uma caixa que seria o "interrupt...
A simple but flawed idea to make a fixed frequency variable duty cycle oscillator based on a 555
timer and using the push-pull output to drive the RC timing through two routing diodes, a pot and a
series resistor to limit the min/max duty cycle to something sensible at around 9%/91%.
If the diode drops were negligible and the 555 timer output pulled fully up to VCC and down to
Water detector with 4 level stages. Each stage makes the 555 timer to give a supply period for the buzzer. The active buzzer transmits sound with a pause period between 0.5-3 seconds, depending on the level detected.