This is little board I made to help me with ATTINY chips projects.
It has 6 pin USBASP input and 4 pin headers for each of the pin of the chip times 3, which makes it easy to connect oscilloscope and put it on breadboard in same time and still have pins to connect to it external device. Also it has both SOIC8 and DIP8 packages support.
Tiny little helper.
USBasp - USB ISP/TPI programmer stick for Atmel AVR microcontrollers with 5V and 3.3V target voltage based on the design by Thomas Fischl. More information can be found at https://www.fischl.de/usbasp/. Windows users may need to install a driver. Of course this is not necessary for linux and mac users.
|TGTVCC|Close to power target device via ISP header|
USBasp - USB ISP/TPI programmer for Atmel AVR microcontrollers based on the design by Thomas Fischl. More information can be found at https://www.fischl.de/usbasp/. Windows users may need to install a driver. Of course this is not necessary for linux and mac users. Close SELFPROG jumper when uploading firmware. If you are burning a fresh microcontroller, close the Slow Serial Clock jumper (SLOWCLK...
Based on Great Scott idea:
Simple (yet powerful :P ) ATTiny programming shield.
Pin 4 connected to LED for simple blink test etc.
Design was enhanced since photo was made. "Yellow LED" is now further from IC,
so ATTiny is easier to grab :)
If you see any mistakes - let me know :)