Как сделать WiFi MicroSD. Сетевой диск из флешки: https://www.youtube.com/watch?v=wonXAKabq_0
How to make WiFi MicroSD. A network drive from a USB flash drive: https://www.youtube.com/watch?v=wonXAKabq_0
Homely WSN Basic Board V2 is an IoT board to collect environmental data (temperature, humidity, and pressure) and to push them to a centralized server through Wi-Fi. This is the enriched successor of the Basic Board V1, that improves different aspects:
- energy efficiency (lower consumption during deep-sleep)
- onboard recharge for single-cell Lipo battery
- measurement of battery level based on...
A **USB ESP8285 WiFi enabled HID hacking device** that gets fully (and stealthy) insertet into the USB port of your friend to unvolunarily move his mouse in Minecraft...
Look at: https://github.com/SinanAkkoyun/ESPUSB/
A fully featured board based on ESP8266 and MAX31855 for managing temperature of electric ovens either by on-off or by pid control. The board supports 2 independent temperature probes and 2 relays for 2 independent heaters. All the operations (set temperature, start, stop, status monitoring) are performed by accessing a standard html webpage with a browser (software is found at https://github.com/...
LED controller for LED-strings, -strips and -rings with individually addressable LEDs.
The controller offers a wide spectrum of usefull functions:
- I²C front panel connector for a on display UI and rotary controller.
(for use with DUPPA.NET's I²C rotary controller and a I²C OLED Screen)
- WIFI AP AND Standard Mode, for use with and without existing Wireless network infrastructure.
A very small unit for controlling RGB LED Strips.
All outputs should be pwm and i personally use OPENHAB2 for my MQTT Broker.
Flash with espeasy or Tasmota and set up to your own system.
I have several of these around my home and they work perfectly everytime.
Tried and tested :)
It has a space for a PIR sensor and a room temperature sensor
Will work with any MQTT Broker if set up for it.
В этом проекте Мы разрабатываем устройство управления низковольтными нагрузками на базе популярного микроконтроллера ESP8266. За основу была взята широко известная универсальная плата Wemos D1 mini, на которой установлен преобразователь интефейсов USB-COM и ESP8266 c LDO стабилизатором напряжения на 3.3В. Это позволило создать устройсво удобно программируемое и с хорошими техническими характеристи...