**Capacitance meter with a current source to measure C from 1 pF to 400+ mF range**
At the beginning of a huge thank to you for the Dillon from EasyEDA Team for helping to make this documentation. Without him, t...
HV UPDI (High Voltage Unified Program and Debug Interface) programmer for the new tinyAVR 0- and 1-series microcontrollers built on ATmega8/88/168/328 based on the design and the firmware by Dlloydev (https://github.com/Dlloydev/jtag2updi). The HV UPDI programmer will enable you to use the additional configuration settings for the UPDI pin without the fear of getting locked out from the MCU. It fe...
# Watering System #
This is a simple **wat**ering **sy**stem based on ATTinyX5 MCU.
Note: this project is intended to be powered by a 3xAA battery pack and a CR2032. The MOSFETs used in this project might not be able to dissipate power from voltage-stabilized source - this case was not tested.
The components are
- Control board (this project)
- 3V-6V powered DC motor water pump with flyback di...
Simple USB ISP programmer for Atmel AVR microcontrollers. More information can be found at https://dicks.home.xs4all.nl/avr/usbtiny/. Windows users may need to install a driver: https://learn.adafruit.com/usbtinyisp/drivers. Of course this is not necessary for linux and mac users.
Stand-alone High Voltage Serial Programmer and Fuse Resetter for ATtiny 13/25/45/85.
Project Video: https://youtu.be/2Q7D2RwkOMg
This work is licensed under Creative Commons Attribution-ShareAlike 3.0 Unported License.
TinyKnob is a rotary encoder with a USB interface based on the ATtiny45/85 and the V-USB software-only implementation of USB1.1 devices on AVR microcontrollers (https://www.obdev.at/products/vusb/index.html). The example code implements a volume control knob for PCs which works without installing any driver by acting like a generic HID device.
Simple logic probe for 5V TTL and CMOS logic based on ATtiny13a.
USBasp - USB ISP/TPI programmer stick for Atmel AVR microcontrollers with 5V and 3.3V target voltage based on the design by Thomas Fischl. More information can be found at https://www.fischl.de/usbasp/. Windows users may need to install a driver. Of course this is not necessary for linux and mac users.
|TGTVCC|Close to power target device via ISP header|
USBasp - USB ISP/TPI programmer for Atmel AVR microcontrollers based on the design by Thomas Fischl. More information can be found at https://www.fischl.de/usbasp/. Windows users may need to install a driver. Of course this is not necessary for linux and mac users. Close SELFPROG jumper when uploading firmware. If you are burning a fresh microcontroller, close the Slow Serial Clock jumper (SLOWCLK...
Mini UPDI programmer (jtag2updi) for the new tinyAVR 0- and 1-series microcontrollers based on the ATtiny1604/1614. Program the new ATtiny devices with a new ATtiny device!
How to use a UPDI programmer video: https://youtu.be/OVSLsA9-gF0
More information and firmware: https://github.com/ElTangas/jtag2updi
Getting started with the new ATtiny chips: http://www.technoblogy.com/show?2OCH