LiPo Power Board is a power manager for your battery-powered product. Since the *breakout* format, it is intended for prototyping and development. It is designed for a single cell LiPo battery (3,7V) and to supply 2 voltages: a fixed 3.3V and a secondary adjustable output, able to deliver higher voltage and current. A physical switch allows you to cut out the voltage on both channels. USB-C and Ja...
Breakout board for the Electronic Assembly eDIP240-7 display for control via an I²C interface.
- I²C addresses can be set via a dip switch.
- I²C pull-up resistors integrated.
- With reset button to avoid annoying plugging in and unplugging.
Use pin headers (2x 1x20) to be able to detach the display from the board
This is the reference design of ESP32-S2, as provided by Espressif in the [original document](https://dl.espressif.com/dl/schematics/ESP32-S2-SAOLA-1_V1.1_schematics.pdf). This schematic will help you to start new projects on EasyEDA without redesigning everything from scratch.
This breakout board for the KFLOP motion controller GPIO Connector (JP7) provides the option of direct connected IO with pull down resistors and filter capacitors or Optically isolated inputs that an be used with 3.3V to 24V signals.
Design is provided as is. It is the users responsibility to determine if design is correct for their application.