This is a small pcb that is designed to be used on an electric go-kart to display a stopwatch, motor RPMs, and cart speed as well as record this data on an SD card with a time stamp for analysis. The project is Arduino based and is ran off of 7-59 VDC or directly from a 5V source through any of the 5V or VIN pins on the data logger shield (this is not a protected input). It is designed to have w...
Sensor for sound detection, the module has two outputs:
AO, analog output, real-time output voltage signal of the microphone
DO, when the sound intensity reaches a certain threshold, the output high and low signal
The threshold-sensitivity can be adjusted via potentiometer on the sensor.
[For more information](https://www.adrirobot.it/sensori/37_in_1/KY-037_KY-038-Microphone-sound-sensor-module.ht...
The KY-001 Temperature Sensor Module consists of a DS18B20 single-bus digital temperature sensor, a LED and a resistor.
[For more information](https://www.adrirobot.it/sensori/37_in_1/KY-001-Temperature-sensor-module.htm)