![Automotive 12V to 5V USB charger assembled PCB]
This project presents a nominally 12V to 5V step down power adapter for use in a motor vehicle to supply 5V at up to 2A from a USB socket.
It is intended to be plugged into a cigar lighter socket in a car or other vehicle and can be used with any device that is normally charged from a 5V USB power outlet at up to 1.8A.
Although most rec...
Simulations created in development support of:
1. Design and simulation of a stable input filter for the 12V to 5V SMPS.
2, Several outline schemes for the output overvoltage protection shunt clamp.
The actual project as shown in the above link has been successfully built and tested.
![enter image description here]- Load resistor(нагрузочный резистор)
Charger 5V on KP142EH5A with radiator for transistor VT1 and with load resistor. **(WITHOUT LOADING THE OUTLET SCHEME WILL GIVE SAME THAT AND AT THE ENTRANCE !!!)**
Зарядка на 5V на основе кр142ен5а с радиатором для транзистора VT1 и нагрузочным резистором. **(БЕЗ НАГРУЗКИ СХЕМА НА ВЫХОДЕ БУДЕТ ДАВАТЬ...