TWO PCB ONE BOARD
posted by TintinC ,
6 years ago.
replied by andyfierman ,
4 years ago.
KiCad - Milling/ Breakout slots - Is my solution ok/ allowed?
posted by d4ey ,
6 years ago.
replied by andyfierman ,
6 years ago.
Connecting rat lines to PCB pads
posted by wraadefects ,
6 years ago.
replied by andyfierman ,
6 years ago.
Track to pad error on multiple solid areas
posted by CRISSTERRIAN ,
6 years ago.
replied by andyfierman ,
6 years ago.
Trouble understanding what's is wrong here
posted by dafunkmonkey73 ,
6 years ago.
replied by dafunkmonkey73 ,
6 years ago.
verify pcb connections
posted by ad26036 ,
6 years ago.
replied by andyfierman ,
6 years ago.
Mapping different schematics to different PCBs under the same project
posted by osama_salah ,
6 years ago.
replied by osama_salah ,
6 years ago.
Can a section of schematic be copied and pasted into a different project?
posted by LISA_DALTON ,
6 years ago.
replied by JFK422 ,
4 years ago.
after I have placed a component, how do I find which one of many it was from the component library?
posted by mc1741p ,
6 years ago.
replied by andyfierman ,
6 years ago.
Pad stop to run
posted by JosEda ,
6 years ago.
replied by andyfierman ,
6 years ago.
Potentiometer component
posted by wraadefects ,
6 years ago.
replied by andyfierman ,
6 years ago.
Copper Area
posted by kirhim ,
6 years ago.
replied by andyfierman ,
6 years ago.
Passive components connected in schematic are not connected by ratlines on PCB
posted by rectifryer ,
6 years ago.
replied by rectifryer ,
6 years ago.
How do I move a pcb track onto another layer?
posted by wraadefects ,
6 years ago.
replied by Serotonindude ,
3 years ago.
[Regulated Dual Supply ] Easyeda 7805 7905 Pin error?
posted by Xons ,
6 years ago.
replied by andyfierman ,
6 years ago.
Designing PCB adapter: SSOP20/30 to DIP20/30. Need a Glancing over, plz
posted by korishantalshin ,
6 years ago.
replied by korishantalshin ,
6 years ago.
Make Value component to be visible
posted by ainfirdaus ,
6 years ago.
replied by MikeDB ,
5 years ago.
can't change pad layer position on cloned part
posted by MuchMore ,
6 years ago.
replied by andyfierman ,
6 years ago.
Hole sizes?
posted by hsandel ,
6 years ago.
replied by andyfierman ,
6 years ago.
Moving Components appears to change links between components...?
posted by corkyo4 ,
6 years ago.
replied by andyfierman ,
6 years ago.
HOW I CAN RENUMBER COMPONENT IN A MULTIPLE SCHEMATIC PRJECT
posted by Mike_November ,
6 years ago.
replied by andyfierman ,
6 years ago.
ground plane issue
posted by studiomollan ,
6 years ago.
replied by studiomollan ,
6 years ago.
UNABLE TO ASSEMBLE AND ASSOCIATE FOOTPRINT W/TEST POINT
posted by LISA_DALTON ,
6 years ago.
replied by andyfierman ,
6 years ago.
Rotate component on PCB other than 90 degrees?
posted by hsandel ,
6 years ago.
replied by andyfierman ,
6 years ago.