Автор — поляк Pawel Kisielewski.
ПРИНЦИП РАБОТЫ УСТРОЙСТВА
— очень прост – подаем на плату 12 вольт, вставляем в панельку «запорченный» микроконтроллер, нажимаем кнопочку «START» и через доли секунды получаем новенький рабочий микроконтроллер. Очень просто, даже не нужен компьютер (всегда возмущают псевдо навороты, в виде управления при помощи специальной программе на PC, там, где это в принципе...
This project is rework Schematics and PCB 3D Wire Bending Machine from [howtomechatronics](https://howtomechatronics.com/projects/arduino-3d-wire-bending-machine/)
- Adding servo connector
- Power regulator is used [Mini DC-DC 4.5-24V To 5V 3A](https://www.aliexpress.com/item/32768078949.html?spm=a2g0o.cart.0.0.10f63c00YJjLX9&mp=1)
This controller is absolutely cold in operation and allows power...
# **DIY JBC 245 Controller (not tested yet)** #
Wich can be powered with a standart 19V DC laptop charger.
The project based on the Atmel328 μc, and i try makes simple as i can. The first problem driving a jbc tip is the thermocouple and the heater have a common pin and its not the GND. On some forum i found the easyest way to do is just siple pass the heater current on the thermocupple but thats...
A multipurpose LoRa microcontroller board based on the Atmel 328P microcontroller with an RFM95W LoRa module attached. This version also has an onboard solar power LiPo charger for the integrated 18650 LiPo battery.
# Spécifications #
Le but de ce projet est de contôler la température d'un balon d'eau chaude sanitaire (ECS) grâce à 2 capteurs (un en haut et l'autre en bas du ballon) pour commander une chaudière via un contact sec (normalement ouvert ou normalement fermé).
La commande de la chaudière se déclenche dès que la température de la sonde haute descend en dessous du seuil fixé et s'arrête dès que la...
Using nrf24L01 and ATmega328p to interact with various instruments and communicate the values to main server. One way only. No two way communication between server and meter.
Programmer for Atmega328p and ATTiny24/25/44/45/84/85
Uses Arduino Nano as ISP
Has a built in Blink test LED
ATTiny24/44/84: port 1
Atmega328p, ATTiny35/45/85: port 3
A simple, single-sided board that can be used to display various patterns with WS2812Bs and an attiny of your choosing.
TODO:
- Refine layout
- Add LIPO charger circuit
We use cookies to offer you a better experience. Detailed information on the use of cookies on this website is provided in our Privacy Policy. By using this site, you consent to the use of our cookies.