Hi,
If I set Spoke Width "0" in copper area, it renders traces to a "default" value. IMHO, this is counter-intuitive since the traces should disappear if the width is 0. However which is this value?
Best regards
Zero spoke width makes no sense.
Having zero spoke width would disconnect the pad from the copper area.
You can toggle between having spokes and solid pad to surrounding copper area in the right hand panel in the same way that you can change the spoke width.
The default poke width is not a fixed value. It is a ratio based on some function of the pad dimensions and possibly the clearance value.
I do not know what that function is.
> Zero spoke width makes no sense.
I'm agree with this, but also 0 cannot mean default, maybe a checkbox or a value limiter may help. But of course this is only my opinion.
> I do not know what that function is.
Ok thanks, this was what I was looking for. Will you add the personalization of this formula just like "teardrop" formula?
We use cookies to offer you a better experience. Detailed information on the use of cookies on this website is provided in our Privacy Policy. By using this site, you consent to the use of our cookies.
