I tried to ignore this warning but couldn't understand the problem. I want to remove the warning to make the PCB and enable the Cross probe and place tool (which is not working due to this warning). Please help!
I tried to ignore this warning but couldn't understand the problem. I want to remove the warning to make the PCB and enable the Cross probe and place tool (which is not working due to this warning). Please help!
Check the pads in the Footprints in the Footprint Editor for each component that you have used. Sometimes they have been incorrectly created with netnames applied to one or more pads.
If that is what has happened then you need to replace (or edit) the Footprint with one that has no netnames applied to the pads: they should be blank so that they can inherit the names of the nets that you connect to them.
Hi!
This error means that somewhere else in your schematic you have named your GND also with net label of PB-.
Although, I can't confirm that 100% because your project is not public.
Regards,
Markus Virtanen
HW / Electronics Designer