In situations like this you have to draw track in two segments. A full width track up to just clear of the pins then a narrow  track from the pin to the end point of the wide track. Your project is private so only you can see it but from your description and screenshot it looks like you have: 1. Created the PCB directly instead of from a schematic;  2. Turned off blocking routing if there is a conflict (i.e. set Routing Conflict to Allow);  3. Turned off Realtime DRC; All of these actions significantly increase the risk of introducing errors in the PCB and you are strongly recommended to follow the essential checklists (4) and (6) in (2) in: [https://easyeda.com/forum/topic/How-to-ask-for-help-and-get-an-answer-71b17a40d15442349eaecbfae083e46a](https://easyeda.com/forum/topic/How-to-ask-for-help-and-get-an-answer-71b17a40d15442349eaecbfae083e46a)<br> <br> <br> At the very least you should run the PCB Design Manager and check that all the nets are connected and that there are no DRC errors before submitting the PCB for fabrication.