I'm trying (for the first time) the jlcpbc assembly service. I've noticed on the DFM Analysis, that on my original part placement many parts orientation was wrong. jlcpcb actually fixed most of the problems themselves (and contacted me about one part they were not sure about), but why was the orientation wrong on the first place? I created the project on EasyEDA and used the standard parts supported by jlcpcb. The PCB looks correct on EasyEDA PCB view. So my expectation was that part orientation as viewed on EasyEDA PCB view would be reflected on the DFM Analysis, but that's not the case. Could this be a bug on the EasyEDA-->jlcpcb assembly workflow?