Hi,
I'm working on a small board and was planning to try out the new assembly service. Thus far everything looks good, apart from one issue. In my design I'm using a STM32F072CBT6 (UFQFPN-48), which appears to be rotated incorrectly in the Pick&Place preview.
Is this a bug in EasyEDA generating incorrect rotation data, or is this a bug in the preview generator showing an incorrect rotation? Pin 1 should be in the bottom left corner.
P&P Preview:  (Rotation -90?)
EasyEDA:  (Rotation 0, as in CPL)
Thanks
Firefox
71.0
Windows
10
EasyEDA
6.2.46