Using the EU resistor from the “Widget” box: a) If I drop it elsewhere in the schematic, close the tool (double right), select it again and drag it over a wire it sometimes is connected correctly, but sometimes the wire goes through the resistor, connecting it crossed over ??? b) I got the same (but very seldom) directly from the toolbox onto the wire. Not sure, but it seems to help drawing the wire from bottom right (start) to left, up, top right (end). It doesn’t matter if parts are connected to the wire or not. Example schematic: Text, Resistor and Wire c) ===> But the “Save” has changed the behavior of the schematic !!! Both resistors were wrong at the upper U, they were OK at the middle U, and different on the lower U. Now it’s always “wrong” (crossed). ---> Try a new one from the toolbox, here at my machine it is OK? d) Now try a new resistor US style directly from the “Widget”, here it is crossed !