Hello there I am trying to make single layer PCB but in my lay out some wires are overlaps, hence when i try to make PCB it get double layer (Surface and bottom). To solve this problem i tried to add jumper in layout but it not works how could i solve this problem. please help. See pictures as follows [Layout][1] ![PCB][2] [1]: /editor/20160915/57da38931143a.jpg [2]: /editor/20160915/57da38931143a.jpg Regards, Amol!

Why not use just design it with 2 layers? If you order your PCBs from EasyEDA then the cost of a 2 layer PCB is the same as for a single layer board. ![enter image description here][1] If you are designing a single sided board because you want to etch it yourself then please see: https://easyeda.com/forum/topic/How_do_I_make_a_wire_jumper_link_-R1wqkCUc6 Don't forget to make the net names different on each side of the jumper/link. The net may be the same to you because it it joined just by a piece of wire but to a schematic capture or PCB design tool there is one net going to a wire link or jumper component and a *different* net coming out of it. Please also see: https://easyeda.com/forum/topic/SZIP24_through_hole_package-49lVv5EeO about the advisability of designing your PCB from a schematic rather than directly in the PCB editor. :) [1]: /editor/20160915/57da6c70642d2.png