Screenshots to illustrate the issue? Project to demonstrate the behaviour to share?

Here's a screenshot How do I share the project?

Try searching the forum for "How to share a projects" and find: [https://easyeda.com/forum/topic/How-to-make-a-Project-public-and-share-the-links-to-it-9f006513b84b412580910905b0281d20](https://easyeda.com/forum/topic/How-to-make-a-Project-public-and-share-the-links-to-it-9f006513b84b412580910905b0281d20)

I've been through the process a couple times.  Not sure if anything is actually shared.  Should it show up here?

I see that the project has been published on OSHWLab.  And actually all my projects were published.  So guess I got a little confused in the process.  The new project I created as part of the publishing process is empty.  The one I'm having trouble with is there under "Serial - master"

Please  help us all out by posting the url to the public project you wish to share and clearly identify which PCB in that project that you are referring to.

The project ended up here: [https://oshwlab.com/jared77441/transition_pcb-02](https://oshwlab.com/jared77441/transition_pcb-02) Then if you open in editor it's this one: 

So I guess I've changed my mind on auto route.  Looking through forum posts it appears that AR doesn't have a real good reputation for working consistently and lot's of comments seem to point in the direction of manual trace.  I was looking for the easy way out just to get a couple board done but will accept that that's probably not going to happen.  So I'll look at learning how to manual route instead. Thanks