This software is so full of bugs. Just give up now. Or maybe someone will defend their position. Waiting. Mike.

Hmm, you speak from experience? What's the alternative? Have seen a few makers on YouTube use it...

@tfmeier, Run the PCB Design Manager with only the Ratline layer visible in the Layer palette to see if a segment is unrouted. Also have a look for any warnings in Nets in the PCB Design Manager. Some screenshots of the layout might be helpful. If you can make your project public and post the link to the project, it would be easier to offer suggestions for help. Otherwise, please have a look at the Tips paragraph of the section suggestions for improving the success of auto routing here: [https://docs.easyeda.com/en/PCB/Route/index.html#Local-Auto-Router](https://docs.easyeda.com/en/PCB/Route/index.html#Local-Auto-Router)

@andyfierman Thanks for the tips. Will do some research first on the points you mentioned to see whether I'm getting to the bottom of it and come back if I'm not getting anywhere

@tfmeier, You're welcome. :)

@andyfierman Installing the local router did the trick. Also looking at the ratlines showed me where the issue was. Great stuff

@tfmeier, Glad that got you going again.