I am having an issue where I want to have a ground plane. I add the ground plane to the schematic, but when I go to do the auto routing, the ground plane gets deleted and the auto router routes through where it should be. Am I doing something wrong?
I am having an issue where I want to have a ground plane. I add the ground plane to the schematic, but when I go to do the auto routing, the ground plane gets deleted and the auto router routes through where it should be. Am I doing something wrong?
Yes, We will remove them.
Please run the autoroute before add the copper plane.
It would be far better if those planes can be designated to not be ripped up.
Hi, this is a feature, I would also like to see.
It is a bit annoying to rebuild the copper area each time, after the auto routing.
Thanks!
Gerd
@Gerdmuller.De We are testing the function, will be online at next big upgrade.
@Gerdmuller.De @Mesopcb
At the new version V3.7.5 , This feature is online.
I'm experiencing the same issue with 3.8.1 today, It worked as expected about a week ago.
Have you tried placing the copper plane area first, assigning it a netnames and then telling the autorouter to not rip up nets?
Or, tell it to skip the netnames that you have assigned to the copper area?