Can you make your failing stripped down project public so others can see it to help?

@andyfierman so it turns out it's got to do with these buttons in the project. The Schematic is blank for some reason on the landing page. [https://oshwlab.com/ianscott1024/unroutable-buttons](https://oshwlab.com/ianscott1024/unroutable-buttons)

@ianscott1024, There are some problems with the symbol and the footprint. 1. The symbol pins are off-grid. 2. The symbol pins don't properly represent the pads on the footprint. 3. Although the symbol pin and the footprint pad numbers match, they are not numbers: they are a mix of numbers, text and other symbols. 4. The User Contributed symbol and footprint do not provide sufficient supplier or manufacturer information to identify the part and therefore to verify either the symbol accuracy or the footprint dimensions against a datasheet. I'm not sure which of these if any is the critical error but I have created a new symbol and footprint: NKK\-KP01\_NUMBRD\_PINS which corrects all these issues. Replacing your original symbol choice and then updating the PCB will allow Autorouting to complete. <br> <br> <br> <br>

@ianscott1024, Interestingly fixing your issue helped identify at least one problem in this topic: [https://easyeda.com/forum/topic/INVALID-PCB-Error-428aeed034a240a082f06945b6846109](https://easyeda.com/forum/topic/INVALID-PCB-Error-428aeed034a240a082f06945b6846109)<br> <br> :)