[https://easyeda.com/memecode/teensy-midi-board](https://easyeda.com/memecode/teensy-midi-board) I'm trying to convert this to a PCB but it complains about the pin numbers on the teensy being not the same as the pad numbers. This is a library component that I haven't edited. So I don't understand why it should be a problem. Neither do I know how to fix it. I'm not using the bottom pins at all so can I turn them off or something? If I can into the foot print manager all the bottom pins are in red... is that bad? The image presented in that display is too small to see all the lines anyway. Can someone tell me what to do here? (I did a bit of googling but didn't find a solution) Regards