So - targeting 4 layer board -- Out signal layers, in 2 are vcc and gnd.
So, I declared them in them in the layer manager and defined them as 'vcc' and 'gnd'
When I look at a component with vcc and gnd nets, I think I see the connection with thermals for the GND pins (through hole), on BOTH VCC and GND
Has anyone else tried doing this. ? or do you manually have to tie each pin in to the net. It appears to me that it only supports a GND Plane, NOT a vcc plane ? Am I correct ?
Brand new interactions and interfaces. 
Easy to use and quick to get started. 
