I am probably doing something wrong, but when I move components (or selections) in the diagram, the connections (wire-lines) is either stuck (break apart in strange places) or gets distorted in strange angles. In effect this means, that entire connection-nets have to be either redrawn or rubber-banded (one by one) again, when components are shifted around during design. I find this behaviour very limiting to the over-all performance of the diagram-tool, and consumes a LOT of time during design. Is there some kind of parameter I need to address to make the 'wires' move (extends and shortens accordingly) with it's connected component, in an orthogonal fashion ? Thanks in advance for any advise. ..Jesper