All junctions in EasyEDA are added auto. where is need a junction, we will add one. Maybe I didn't understand your question, you can create an image and add a link at below. when you need to change the junction's color, size, just select it and change them from attribute panel. Dillon.

At the same time, there are some users use some bad `sanp size` such as 3.1 ,5, 7, 0 , the best snap size is 10 or 5, so there are no junctions, because can't find the junction point

By right when connect the wire to a junction (for example T junction). I found "junctions" not all the junction attribute were created automatically.

Hi, Can you create a public project for us to show thiese, we are glad to check what are the problems? Thanks.

Thanks. After configure the snap size to 5 or 10 and snap to "Yes", this issue has been resolved :)

I have all snap settings set to 5 and snap enabled, but I'm still getting non-connected points. Zombie thread, I know, but I'm having the same issue.