Hello, It would be very helpful if we could save our prefered canvas setup and have it used for all future PCBs. For example, when I start a new PCB, I change the units from mm to inches, and the secondary snap from 0.005 inches to 0.05 inches.  I have to do this every time. And one of my PCBs had a pin that needed to be marked with the Greek letter Phi (ϕ), which the Default font doesn't support, so I have to use an imported font. I'd like to make that font the default font on my PCBs so that not only text gets added in that font, but when a component gets added to the board, its lettering is in that font. While I haven't changed any setting on the schematics canvas, I can see this feature being a big help there as well. Thank you, Rick