Hello ; Please to change the topic of the post to "Bug Reports"

yap happend to me allso its a bug but try to check sometimes there is small nets left overs under the pads

@maasijam, Are they connected by a GND plane that is not shown in your screenshot?

@andyfierman No, there is no ground plane or small nets left under the pad. I've just created a new project with a new pcb.  Then two pads with GND net - no errors. Here you can find my test project: [https://easyeda.com/maasijam/tteesstt](https://easyeda.com/maasijam/tteesstt) 

* I can confirm this as a bug. Even if you delete one of the GND pads in the example above, the Design Manager still shows no warning of incomplete net.

Ok, thanks for your effort. I found out that if I draw a "Copper area" (with net "GND") around the pads and then delete this area again, the design manager then shows the errors. Strange.

@maasijam for your demo, that is because of the ratline layer hidden. please enable it. we will solve this issue Thanks