Please read:
[https://easyeda.com/forum/topic/How-to-ask-for-help-and-get-an-answer-71b17a40d15442349eaecbfae083e46a](https://easyeda.com/forum/topic/How-to-ask-for-help-and-get-an-answer-71b17a40d15442349eaecbfae083e46a)
Then do what it says in **Sharing** in the Tutorial.
With reference to the screenhot above, I want to etch thi double sided booard myself as it is a one off requirement. My problem is that i cannot have PTH for this so i must have the upper and lower track interconnects not at the pads of U1 and the connectors. The resistor pads can be soldered from both sides. I will need to do the same for XTAL1 and C3.
How can I do this? I hope my question/ help requirement is clear.
If I need to make this public, I tried it but couldnt do it. How to make it public.
Best Regards.
Karanbir.
**Either**:
Click on the Share icon on the top toolbar;
**Or**:
Right click on the Project folder in the left hand panel.
Click Share.
**Then**:
Copy and paste the link to the **Project**.
@karansoi,
Plated through holes are produced during professional PCB fabrication.
If you are etching this PCB yourself then you will not get plated through holes so you do not need to do anything.
Just follow the instructions in the Tutorial about how to generate prints for DIY PCB etching.
**_Please take care when using etching chemicals and dispose of them responsibly. _**
Our website uses essential cookies to help us ensure that it is working as expected, and uses optional analytics cookies to offer you a better browsing experience. To find out more, read our Cookie Notice